Description
Yato cordless vacuum 18V set (YT-85682) is a cordless handheld vacuum supplied as a ready-to-use package: it comes with a Yato 18 V Li-Ion system 4.0 Ah battery and a charger. The vacuum’s power is 150 W and the vacuum it produces 9 kPa, which is enough for collecting sand, crumbs, dust and chips.
The design is bagless: dirt is collected in a transparent dust container with a washable HEPA filter. The container is removed with a single locking button, emptied and rinsed. The vacuum is intended for dry use : liquids, wet ash or dirt hotter than 40 °C must not be vacuumed.
Without the battery the unit weighs 1.0 kg, which together with being cordless makes it practical for cleaning vehicle interiors, workshop benches, stairs and furniture. The slide switch locks in the I position, so you do not need to hold the switch down while working. Charging the battery takes 2 h.
The vacuum comes with two extension tubes and three nozzles: a wide floor nozzle, a narrow nozzle and a crevice nozzle. The nozzles fit directly into the front opening of the container or onto the end of the extension tubes, giving enough reach for the floor and under car seats. The battery in the set is the same as in the other tools in the range, such as the Yato cordless pressure washer 18V 23 bar model, and it can also be charged with the Yato battery charger 18V 2.4-4.5A smart fast charger .
Uses and suitability:
The Yato cordless vacuum 18V set is intended for small dry cleaning jobs in the household, workshop and vehicles.
- Cars and work machines: cab floors, seats and shelves are cleaned without mains power; the narrow and crevice nozzles reach between the seats.
- Workshop and workstation: collecting sawdust, drilling dust and chips from workbenches and around machines; the HEPA filter traps fine dust.
- Home: stairs, furniture, crumbs and sand in the hallway; with the extension tubes also floor surfaces without bending down.
- First Yato 18 V tool: the battery and charger in the set fit other tools in the same system as they are.
The unit is not suitable for vacuuming liquids, wet dirt, hot ash or flammable substances, or for continuous industrial dust extraction.
Package contents:
- Handheld vacuum YT-85682 (body, dust container and HEPA filter)
- Yato 18 V Li-Ion battery 4.0 Ah
- Battery charger
- Extension tube, 2 pcs
- Narrow nozzle
- Wide floor nozzle
- Crevice nozzle (upholstery nozzle)
- Instruction manual
Features:
- Power 150 W and vacuum 9 kPa: enough suction for sand, crumbs, dust and chips.
- HEPA filter: washable and replaceable filter traps fine dust.
- Bagless dust container: the transparent container is removed with the locking button and emptied without dust bags.
- Locking slide switch: the I/0 switch stays in position, so you do not need to hold it down.
- Weight 1.0 kg without battery: can be used with one hand.
- 4.0 Ah battery and charger included: charging time 2 h; the charger’s indicator lights show the charging stage.
- Three nozzles and two extension tubes: floor, narrow and crevice nozzle; the connection sizes only allow correct assembly.
- Yato 18 V battery system: compatible with batteries YT-828461…YT-828465 and chargers YT-828498…YT-828504.
- Protection class III (unit) and II (charger).
Technical specifications:
- Voltage: 18 V DC
- Power: 150 W
- Vacuum: 9 kPa
- Use: dry use, bagless
- Filter: HEPA
- Battery: Li-Ion 18 V, 4.0 Ah (4000 mAh), 1 pc
- Charging time: 2 h
- Charger: 200–240 V~ 50/60 Hz, 1.5 A, output 21.5 V DC 2.2 A, protection class II
- Protection class (unit): III
- Weight without battery: 1.0 kg
- Maximum temperature of dirt vacuumed: 40 °C
Instructions for using the Yato cordless vacuum 18V set:
Charging the battery: The battery is supplied uncharged. Put the battery in the charger and plug the charger into a socket; the indicator light shows charging (red = charging, green = ready). Unplug the charger after charging. Charge only in a dry place under adult supervision.
Preparation: Remove the dust container by pressing the locking button and pulling the container off the body. Pull out the filter and detach it from the base by twisting. Clean the container and filter, fit the filter to the base and place it in the container so that the shapes match. Attach the container to the body; a correctly attached container sits flush all the way round its edge.
Nozzles: Push the nozzle you want into the front opening of the container, directly or via an extension tube. The tubes and nozzles fit together only the right way round.
Use: Push the charged battery into the battery slot until the latch locks. Push the switch forward with your thumb until the I mark is visible; the vacuum starts and the switch stays in position. Stop it by pushing the switch back to the 0 position. If the suction drops or the motor sounds louder, switch off the unit, remove the battery, empty the container and check the tubes and nozzles for blockages.
Maintenance: Remove the battery before maintenance. Check the container and filter after every use. Clean the outer surface and filter with compressed air at max. 0.3 MPa or with a soft cloth; do not immerse the vacuum in water and do not clean the ventilation openings with sharp metal objects. Store the battery at 0–30 °C, at about 70% charge for long-term storage.
Warnings:
- Dry use only: vacuuming water, wet ash or other wet waste is prohibited (risk of electric shock).
- Do not vacuum hot, glowing or burning objects; the temperature of the dirt vacuumed must not exceed 40 °C.
- Indoor use only; not in explosive atmospheres, and not near heat sources or open flames.
- Keep the ventilation openings clear: covered openings can make the unit overheat.
- Switch off the unit and remove the battery before changing accessories, cleaning and maintenance, and after every use.
- Children aged 8 and over and people with reduced capabilities may use the unit only under supervision; children must not play with the unit.
- Use only the supplied or another Yato 18 V charger; do not use a damaged charger or battery. Do not short-circuit, dismantle or burn the battery. If the charger gives off smoke or a smell, unplug it immediately.
Frequently asked questions (FAQ):
What is included in the Yato cordless vacuum 18V set? The vacuum, a 4.0 Ah Li-Ion battery, a charger, two extension tubes and three nozzles. The body alone without a battery is model YT-85683.
Does the battery in the set fit other Yato 18 V tools? Yes. The battery is a Yato 18 V Li-Ion system battery, and the charger can charge other batteries in the range (2–9 Ah).
Can the vacuum pick up water? No. The vacuum is intended for dry dirt only.
Can the filter be washed? Yes. Remove the HEPA filter from the container, clean it with compressed air or wash it, and let it dry completely before refitting.
How long does it take to charge the battery? Charging the 4.0 Ah battery with the supplied charger takes about 2 hours.
Recycling instructions:
Packaging: cardboard box to cardboard collection, plastic bags to plastic collection.
Device: The Yato cordless vacuum 18V set is an electrical and electronic device (WEEE) that must not be disposed of as mixed waste. Take a discarded vacuum and charger to a WEEE collection point or to the retailer.
Battery: remove the Li-Ion battery from the unit before recycling, tape the terminals and take the battery to a battery collection point. A damaged battery must not be sent by post; lithium-ion batteries are dangerous goods in transport.
